Steel Wire Hho
 20m Stainless Steel 316L ANNEALED Wire won't brittle, for HHO hydrogen generator US $12.63 
|
| Powered by phpBay Pro |
Which type of weld should i use for my Hydrogen HHO Generator?
I have made many Hydrogen fuel cells in the past, but i am looking to make a quality one that can be put into a car for long term use. It will use 8 large stainless steel wall plates. Each plate needs to have 1 eyelet welded to it. I was thinking about TIG welding it, and i think that it is about my only option since i am using stainless steel, but is that too hot for a flimsy little eyelet? Also, I am not going to fasten them down with bolts...the metal is hard to drill through and a bolt protrudes too far on either side. I need the plates very VERY close together. (btw, an eyelet is a little metal loop that can be fastened to a bolt or screw hole, and it has a place to crimp wires down on it).
Any welding gurus care to share a little insight?
Please and thank you 
TIG, welding can be controlled very well and is very suitable for small or thin pieces to be joined. One bad thing about stainless is , heat distorts it.which can be controlled somewhat by clamping the piece while welding and letting it cool while clamped . Thickness of the pieces to be joined has a lot to do with it.
Items Recently Purchased From This Site:
| Powered by phpBay Pro |
Leave a Comment